AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
![]() Plus this is completely safe, as the power to mod was given to us by Relic. Originally posted by Antares30:This involves a little modding, so here it is. Replace 'index' with a player number between 1 and 8. Just replace 'Game_GetLocalPlayer()', with 'World_GetPlayerAt(index). It can also be done to other AI players in the game. I haven't been able to go above +1200, or about there. So lets say, you start with +292 Manpower income per minute, entering the line above will times that number by 2 and make it +592. This will multiply the resource per minute rate by 2. Modify_PlayerResourceRate(Game_GetLocalPlayer(), RT_Munition, 2) Modify_PlayerResourceRate(Game_GetLocalPlayer(), RT_Fuel, 2) Modify_PlayerResourceRate(Game_GetLocalPlayer(), RT_Manpower, 2) Here's how to change the resource rate per minute. I'm still trying to figure out how to change the resource gain per minute, instead of just instantly increasing it. I believe you can set the command points to however many you want, but you shouldn't go too high, perhaps staying below 20 should be fine. Player_SetResource(Game_GetLocalPlayer(), RT_Command, 16) Here is the command to set your commander points. You can replace 9999 with any number between. Player_SetResource(Game_GetLocalPlayer(), RT_Munitions, 9999) ![]() Player_SetResource(Game_GetLocalPlayer(), RT_Manpower, 9999) Player_SetResource(Game_GetLocalPlayer(), RT_Fuel, 9999) Then enter this following line EXACTLY, otherwise you'll get a SCAR error and the game will pause (not freeze or hang, just press ESC and then again to unpase): This will open up the SCAR command console. After the map loads, press 'ALT+SHIFT+TILDE(~)'. Once this is done, start up the game and set up a custom game (you will notice that Automatching is disabled, because only other players with the -dev command line can play with you). ![]() What this does is enable developer mode where an ingame SCAR command console can be used. Under the 'General' tab, click on 'set launch properties', and enter this exactly: -dev ![]() In your Steam Games Library, right click on "Company of Heroes 2" and open up properties. This involves a little modding, so here it is. ![]()
0 Comments
Read More
Leave a Reply. |